The IUI sample: post-wash assessment, fit for use
On this page you will learn
- Why semen is never placed in the uterus without preparation
- How to assess a washed sample: volume, concentration, progressive motility and total motile count
- What "fit for use" means and who makes the decision
- How to label, store and hand over the IUI sample with full witnessing
Why the sample is washed
Raw semen contains seminal plasma, which carries prostaglandins, white cells, bacteria and debris. Placed directly in the uterus, it can cause painful cramps and carries a risk of infection. Preparation (pages 10 to 13) removes the seminal plasma and concentrates the motile sperm into a small volume of clean medium. The washed sample is what the clinician inseminates.
The post-wash assessment
Every prepared sample is assessed before it leaves the bench. The assessment uses the same skills as the semen analysis on page 7, applied to a much cleaner sample.
- Final volume: the volume in which you resuspended the sperm, measured accurately with a calibrated pipette.
- Concentration: counted in a suitable chamber after proper mixing, in replicate as your protocol states.
- Progressive motility: graded as on page 7, on a warmed slide or stage.
- Total progressively motile count: final volume multiplied by concentration multiplied by the proportion of progressive sperm. This is the number clinicians use most.
- Remarks: debris, round cells, agglutination or anything unusual.
Compare the result with the initial analysis. A large fall in motility after preparation is a warning sign: it may point to a temperature problem, a medium problem, rough handling or too much centrifugation. Page 15 deals with how to investigate it.
Fit for use: what it means
"Fit for use" means the prepared sample is correctly identified, prepared to protocol, free of visible contamination and assessed. It does not mean a pregnancy is likely. Many laboratories set a minimum total progressively motile count below which the clinician is advised that IUI is unlikely to help. Your laboratory sets its own figure in its protocol. The laboratory reports the facts; the clinician, with the couple, decides whether to go ahead, postpone or change to IVF or ICSI.
Write the report clearly and sign it. Include the time of collection, time of preparation, method used and the post-wash values. A clinician reading it at the bedside should not need to ask you anything.
At the bench
- Gently mix the resuspended sample. Do not vortex.
- Take an aliquot for concentration and motility. Assess promptly, while the sample is at the right temperature.
- Calculate the total progressively motile count and check the arithmetic a second time.
- Label the final tube with the woman's and the man's full names and a second identifier, as your protocol requires. Write on the tube, not the cap.
- Keep the sample in a buffered medium at the temperature your protocol states. A bicarbonate medium outside a gas atmosphere will drift in pH.
- Hand over with witnessing: you and the clinician (or nurse) read the names and identifiers aloud against the request form, and the woman confirms her own name and her partner's name before insemination.
- Note the time of hand-over. Use the sample within the time limit your protocol sets.
Witnessing is not optional
An IUI uses sperm from one man for one woman. A mix-up is a serious, irreversible error. Every transfer of the sample from one container to another, and the hand-over itself, is witnessed and recorded. Page 3 explained the principles; page 55 covers traceability in full.
Common errors
- Mixing too little before taking the counting aliquot, giving a falsely low or high count
- Calculating the total motile count with the volume of the original semen instead of the final resuspension
- Leaving the prepared tube on a cold bench or in direct sunlight
- Labelling only the cap, which can be swapped
- Handing over without a spoken identity check
Check yourself
- Why can raw semen not be placed directly in the uterus?
- How do you calculate the total progressively motile count of a washed sample?
- Who decides whether an IUI goes ahead when the count is low, and what does the laboratory contribute?
- List every point at which the identity of an IUI sample is checked.
Questions on this page
Does a good post-wash count mean the IUI will work?
No. The post-wash assessment tells you the sample was prepared well and how many motile sperm are available. It does not predict the outcome.
How long can a prepared IUI sample wait?
Your laboratory protocol sets the time limit and the storage temperature. Use the sample within that limit and record the times.
Who checks identity at hand-over?
Two people from the team read the identifiers aloud against the form, and the woman confirms her own and her partner's names.
The Genesis ART Textbook is teaching text for trainees and doctors of the Genesis ART Academy. It is not treatment advice and not a laboratory standard operating procedure; every technique is learned under supervision. Page numbers never change.
