Semen analysis II: concentration and motility; CASA vs manual
On this page you will learn
- how to make a wet preparation and why its depth matters
- the four WHO 2021 motility grades and how to count them
- how to measure concentration with a haemocytometer
- what computer-assisted semen analysis (CASA) can and cannot do
The wet preparation
Motility is assessed first, because it falls with time and temperature. Mix the liquefied sample well, then place a fixed volume (about 10 microlitres) on a clean, pre-warmed slide and cover it with a 22 x 22 mm coverslip. This gives a chamber about 20 micrometres deep, which lets sperm swim in one plane. Too little sample makes the layer too shallow and restricts movement; too much makes the coverslip float and the sperm drift.
Wait a few seconds for the drift to stop, then examine the slide with phase-contrast optics at x200 or x400, on a heated stage at 37 °C, as the WHO laboratory manual (6th edition, 2021) recommends. Avoid the edges of the coverslip.
Motility grades (WHO 2021)
The 6th edition returned to four categories:
- Rapid progressive: moving actively forwards, at 25 micrometres per second or faster (roughly half a tail length per second or more).
- Slowly progressive: moving forwards, but more slowly than that.
- Non-progressive: tail moving, but the sperm makes little or no forward progress, for example swimming in tight circles.
- Immotile: no movement at all.
Total motility is the sum of the first three; progressive motility is the sum of the first two.
How to count
- Choose a field at random, at least 5 mm from the coverslip edge.
- Score the progressive sperm in a small area of the field first, then the non-progressive and immotile ones in the same area. A laboratory counter with separate keys helps.
- Move to new fields until you have scored at least 200 spermatozoa.
- Make a second wet preparation from a freshly mixed aliquot and repeat.
- Compare the two replicates. If the difference is larger than the acceptable limit in the WHO table, make two new preparations and count again.
Concentration
Sperm concentration is measured by counting a diluted, immobilised sample in an improved Neubauer haemocytometer, a counting chamber of known depth with an engraved grid.
At the bench
- From the first wet preparation, estimate roughly how many sperm are in a field; this tells you which dilution to use from the WHO table.
- Make two independent dilutions of the well-mixed sample in a fixative diluent, using a positive-displacement pipette for accuracy.
- Load each side of the haemocytometer with one dilution and let the sperm settle in a humid chamber for 10 to 15 minutes.
- Count whole spermatozoa (head and tail) in the central grid squares. Count a sperm whose head lies on a boundary line only if that line is the lower or the left line of the square (the WHO L-shaped rule), so it is not counted twice.
- Count at least 200 spermatozoa in each replicate where possible.
- Compare the replicates against the acceptable difference, then calculate the concentration in millions per millilitre using the dilution factor.
- Multiply concentration by volume (page 6) to get the total sperm number per ejaculate.
Very low counts
If you see no sperm, or very few, in the wet preparation, do not report "no sperm" from one look. Examine more of the sample, then centrifuge an aliquot and examine the whole pellet. Report whether sperm were found and, if so, whether any were motile. The difference between azoospermia (no sperm at all) and cryptozoospermia (sperm present only after centrifugation) matters a great deal for treatment.
CASA versus manual assessment
Computer-assisted semen analysis (CASA) systems capture video of sperm and track each one. They report concentration, motility grades and kinematic measures that the human eye cannot judge, such as curvilinear velocity (VCL), straight-line velocity (VSL), average path velocity (VAP), lateral head displacement and beat frequency.
Strengths
- objective, fast and repeatable once set up,
- useful for kinematics in research and for checking a technician's counts,
- keeps a digital record.
Limits
- debris and round cells can be mistaken for sperm, especially in poor samples,
- accuracy depends on chamber type and depth, frame rate and settings,
- very low or very high concentrations are hard to measure,
- results are not comparable between systems unless each is validated against manual methods.
Manual assessment by a trained person remains the reference method. Use CASA only when it has been validated in your laboratory and is checked by regular quality control (page 15).
Common errors
- Assessing motility on a cold slide or after the sample has stood for a long time.
- Counting only the "interesting" fields instead of random ones.
- Counting immotile sperm first, while the progressive ones swim out of the area.
- Using an air-displacement pipette for viscous semen, which under-delivers.
- Reporting azoospermia without examining a centrifuged pellet.
Check yourself
- Name the four WHO 2021 motility categories.
- Why must motility be assessed at 37 °C and soon after liquefaction?
- How do you avoid counting a sperm twice on a haemocytometer grid?
- Give two strengths and two limits of CASA.
Questions on this page
How many sperm should I count for motility?
At least 200 spermatozoa in each of two replicate wet preparations, then compare the replicates with the acceptable difference given in the WHO manual.
Can CASA replace manual counting?
Only after it has been validated in your laboratory and is under regular quality control. Manual assessment by a trained person remains the reference method.
The Genesis ART Textbook is teaching text for trainees and doctors of the Genesis ART Academy. It is not treatment advice and not a laboratory standard operating procedure; every technique is learned under supervision. Page numbers never change.
