Warming and post-warm assessment
On this page you will learn
- Why the speed of warming matters even more than the speed of cooling
- How stepwise dilution brings water back into the cell safely
- The bench sequence for warming a device
- How to judge whether an oocyte or embryo has survived
Warming is the dangerous half
A vitrified sample is a glass. As it warms it passes through a temperature zone where ice crystals can form and grow (page 45). If warming is slow, small ice nuclei that formed harmlessly during cooling grow into crystals that damage membranes. That is why the critical warming rate is higher than the critical cooling rate, and why the first movement of the warming protocol is the most important: the device goes straight from liquid nitrogen into the warm first solution in one movement, with no pause in air.
Stepwise dilution
After warming, the cell is full of cryoprotectant. If you put it directly into culture medium, water would rush in and the cell could swell and burst. Instead you dilute in steps:
- Thawing solution: a high concentration of sugar, at about body temperature. The device tip is dipped into it at once. The sugar outside holds water back while cryoprotectant begins to leave.
- Dilution solution: a lower sugar concentration, usually at room temperature, so the cell rehydrates gently.
- Washing solutions: no sugar, to remove the remaining cryoprotectant before the cell goes back into culture medium.
The exact times and temperatures come from your validated protocol. Use the same family of solutions for warming that was used for vitrification unless your laboratory has validated a mixed method.
At the bench: warming
- Confirm the patient, the device and the storage address with your witness, and retrieve the device (page 49) into a box of liquid nitrogen.
- Warm the thawing solution to the set temperature and have the dish ready under the microscope.
- Read the label with your witness. Remove the cap or outer sheath under nitrogen if the device requires it.
- In one movement, take the device out of the nitrogen and plunge its tip into the thawing solution. Start the timer. Find the cell at once.
- Move the cell through the dilution and washing steps on time, watching it shrink and then return to normal size.
- Place it in pre-equilibrated culture medium in the incubator and record times, operator and witness.
Post-warm assessment
Oocytes
A surviving oocyte has an intact zona, a cytoplasm that looks like it did before freezing and an oolemma that fills the space normally. A degenerated oocyte looks dark, granular or shrunken, or its cytoplasm has leaked. Most protocols allow the oocyte a recovery time in culture, often around two hours, before ICSI (page 31), so that the spindle can re-form.
Cleavage embryos
Count intact blastomeres. Lysed cells appear dark or have lost their outline. The record states how many cells survived; the clinical team uses this when deciding whether to transfer.
Blastocysts
A collapsed blastocyst re-expands in culture, usually within a few hours. Re-expansion, an intact trophectoderm and a visible inner cell mass are reassuring signs. A blastocyst that has not re-expanded by the planned transfer time is reported to the clinician with an honest description, not a guess.
Planning and communication
Warming is timed to the transfer (page 44) or to the planned ICSI. Agree the time with the clinical team the day before. If the embryo does not survive, the clinician must know before the couple arrive or before the transfer starts, so that the next step can be discussed with them. Record survival in plain words and grade the embryo again before transfer.
Common errors
- Pausing in air between liquid nitrogen and the thawing solution.
- Using thawing solution that has not reached the set temperature.
- Losing sight of the cell in the first solution because the dish was not focused in advance.
- Moving through the dilution steps too fast, causing the cell to swell.
- Doing ICSI on a warmed oocyte without the recovery time in the protocol.
Check yourself
- Why is the critical warming rate higher than the critical cooling rate?
- What would happen if a warmed oocyte went straight into culture medium?
- List three signs that a warmed blastocyst has survived.
- Why should warmed oocytes rest before ICSI?
Questions on this page
Can a warmed embryo be vitrified again?
It is possible, but it adds stress. It is done only in specific situations decided by the senior embryologist and the clinician, and it is recorded clearly.
What if only some cells of a cleavage embryo survive?
Record the number of intact cells. The clinician decides with the couple whether that embryo is suitable for transfer.
Is a blastocyst that re-expands slowly a poor embryo?
Not always. Re-expansion is one reassuring sign among several. Describe what you see and let the team decide.
The Genesis ART Textbook is teaching text for trainees and doctors of the Genesis ART Academy. It is not treatment advice and not a laboratory standard operating procedure; every technique is learned under supervision. Page numbers never change.
