Assisted hatching
On this page you will learn
- How a blastocyst hatches naturally from the zona pellucida
- The methods of assisted hatching and how they differ
- What the evidence does and does not show
- How to use a laser safely and accurately on an embryo
Natural hatching
The zona pellucida surrounds the oocyte and then the embryo (pages 21 and 35). Around day 5 or 6 the blastocyst expands, the zona thins, and the embryo works its way out. Hatching is a combination of mechanical pressure from the growing blastocyst and enzyme activity that softens the zona. The embryo must hatch before it can implant.
Assisted hatching is a laboratory technique that thins or opens a small part of the zona before transfer. The idea is that some embryos, perhaps with a thick or hardened zona, may hatch more easily. You will see it demonstrated on Day 12; as a trainee you learn its principles and assist under supervision.
Methods
- Laser: an infrared diode laser fitted to the microscope delivers short pulses that dissolve a small area of the zona. It is precise, quick and needs no contact with the embryo. It is the method most laboratories now use.
- Chemical: acidified Tyrode's solution, blown gently from a fine pipette, dissolves a small area of the zona. It needs careful control, because the acid can harm cells close to the opening.
- Mechanical: the zona is held and cut with a fine needle (partial zona dissection). It needs micromanipulation skill (page 28).
With any method you may either thin the zona (leaving its inner layer intact) or open it fully over a short length. Your laboratory's protocol states which, and how wide the area should be.
What the evidence says
Assisted hatching has been studied for many years. Systematic reviews have not shown clear evidence that it improves the chance of a live birth when used routinely, and it is not advised for all embryos. It has been used for selected situations, such as embryos with a thick zona, frozen-warmed embryos and couples with repeated unsuccessful transfers, but the evidence even here is limited and of mixed quality. The decision is made by the clinician and the senior embryologist, for a stated reason, and recorded. A trainee should be able to explain this honestly to a colleague: assisted hatching is a tool with uncertain benefit, not a routine add-on.
The same laser is used for other purposes you have already met: collapsing a blastocyst before vitrification (page 51) and opening the zona for biopsy (page 57).
At the bench: laser safety and accuracy
- Check the laser calibration and the target alignment at the start of the session, using the method set by the manufacturer and recorded in the equipment log.
- Place the embryo in a drop of handling medium under oil, with the dish on a heated stage.
- Rotate the embryo with a holding pipette or by gently moving the dish so that the target area is over empty space in the perivitelline area, away from cells. For a blastocyst, aim well away from the inner cell mass.
- Use the shortest pulse that works, and fire the smallest number of shots needed. The heat from each pulse spreads a little beyond the visible hole.
- Check the result: the opening or thinned area is the size the protocol states.
- Return the embryo to culture and record the method, the position, the operator and the witness.
Never aim at the cells themselves. Never fire with the target outside the zona edge. If the laser behaves unexpectedly, stop and report it before any further embryo is treated.
Your role
On Day 12 you watch a faculty demonstration and then practise aiming and firing on discarded material. You do not perform assisted hatching on a patient embryo during the course. Your logbook records what you observed and what you practised.
Common errors
- Skipping the calibration check at the start of the session.
- Aiming too close to blastomeres or to the inner cell mass.
- Firing more pulses than needed.
- Treating assisted hatching as a routine step without a recorded reason.
- Leaving the embryo on an unheated stage while setting up.
Check yourself
- Describe how natural hatching happens.
- Compare the laser and chemical methods of assisted hatching.
- What does current evidence say about routine assisted hatching?
- Why should you use the shortest effective laser pulse?
Questions on this page
Does assisted hatching harm the embryo?
When done correctly with a calibrated laser and good aim, the risk is low, but heat and mishandling can harm cells. That is why it is done only for a reason and only by trained staff.
Is assisted hatching used for every frozen embryo?
No. It may be considered for some frozen-warmed embryos, but the evidence is limited and it is decided case by case.
Will I perform assisted hatching during the course?
No. You see a demonstration and practise aiming on discarded material. Clinical use comes later, under supervision in your own laboratory.
The Genesis ART Textbook is teaching text for trainees and doctors of the Genesis ART Academy. It is not treatment advice and not a laboratory standard operating procedure; every technique is learned under supervision. Page numbers never change.
